d. Heat guns operated above one thousand one hundred (1,100) degrees Fahrenheit;
e. Uncontained sandblasting;
f. Power sanding (unless fitted with a HEPA filter); and
g. Chemical stripping using products containing methylene chloride.
Certification that prohibited work practices were not used must be made by the person doing the work on a form provided by the code enforcement office and kept on file with the owner of the property.
(2) The following practices are not allowed to be used to remove lead-based paint on non-rental target housing:
a. Open flame burning or torching.
b. Use of heat guns operated above one thousand one hundred (1,100) degrees Fahrenheit.
c. Dry scraping.
d. Machine sanding or grinding.
e. Uncontained hydro-blasting or high-pressure washing.
f. Abrasive blasting or sandblasting without containment and high-efficiency particulate exhaust controls.
g. Chemical stripping using methylene chloride products.
Notwithstanding the provisions of section
18-31(a) and (b), if a violation of this subsection is found, the inspector shall issue an order to cease and desist the prohibited practice, remove all visible paint chips and clean the affected area using the safe cleaning methods approved by the state department of health. A failure to comply with such an order is a violation the penalty for which shall be a fine of up to five hundred dollars ($500.00).(e)
Enforcement of lead safe work practices. In addition to all the other enforcement powers authorized by this chapter, inspectors shall have the authority to issue a stop work order if unsafe or prohibited work practices are being performed on target housing.(f)